![]() Small Mandrels – Making consistent turns and loops will make your work a lot cleaner.There are a few other tools a newbie to wire wrapping might find handy: If you do other metalwork you’ll have to make an investment. You’ll lose them before they wear out if you’re only wire wrapping. ![]() If you’re only wire wrapping then a cheap set of files is fine. You push them along the end of the wire and they cut, but drawing them directly back while maintaining pressure on the metal is damaging. Standard files cut only one way, but tend to outlive diamond files. The linked set contains both standard and diamond files.ĭiamond files work like sandpaper on a stick, they’re just a diamond abrasive bonded to steel. If you’re buying a set specifically for wire any small set of files works. Filesįiles or sandpaper aren’t essential but they can help add a cleaner finish to your piece. You can certainly grab a pair of wire cutters from your toolbox, but you’ll spend a lot of time filing as well. The pair of cutters you use needs to be flush cutters or you’ll spend a lot of time on finish work. If you’re looking to get into the bigger fabricated wire pieces or other kinds of work with non-ferrous metals then they’re a better value. I personally use a larger pair you’ll see in the tutorial. Cheap pairs can shatter when cutting thicker wire, a good pair will deform and be easy enough to repair. These usually shouldn’t be used on wire any bigger than 18 gauge(roughly 1mm). Your cutters need to be sharp and strong enough to cut the wire you’re looking at.įor most people a small pair of micro-shears is exactly what’s needed. You can start with a cheap pair of round nose and flat nose pliers without any problems. There are many types available but they’re all going to be rather expensive.īut all of those specialty pliers are really only needed for those planning on getting serious.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |